General description for AL Ω T-BAR

① System: AL Ω T-BAR SYSTEM
② Method; Lay-in (A type whereby ceiling finishing panel is placed on ceiling frame)

① Transportation: Transport after recording type, name, dimension and manufacturing date etc. on the label and then packing.
② Handling: Handle it according to instruction of manufacturer and requirement of the user.

AL Ω T-Bar product

① At the time of strong anchor work when centerline is set up mark part for fixing strong anchor (Ф9mm) at slab surface and punch hole with drill and fix it.
② At the time of work for cash iron insert (Ф9 mm) install it at form according to drawing.
③ Caution: Pay attention to intervals between anchor and insert and right angle.
④ It is ideal to make interval for installation as @900∼ 1,200 mm for strong anchor or insert in consideration of direction of installation of carrying channel.

① Use of water level or level
? ?a. Confirming position by means of drawing (confirming height of ceiling)
? ?b. Confirming the position by water level and ink pot string marking between positions.
② Caution: At the time of using water check make sure to check level after checking any presence of air bubble in hose and breaking of hose.

① Attach molding along the India ink line and fix wall molding by using 1" concrete nail. (interval 500∼ 1,000 mm)
② Be careful not to slacken the height and interval between moldings.
③ In connection with facilities such as curtain box it shall be attached according to specification.

① Upper part of hanger bolt is fixed to strong anchor or insert and power part of bolt is fixed with hanger and nut in consideration of ceiling height at finishing.
② At the place where installation duct or other obstacles are present work shall be carried out after reinforcing it according to specification.

Install lightline according to specification but it is required to have consultation with persons in charge of electricity and facility.

After linking hanger set and carrying channel fix it and install it with an interval of @900∼1,200 mm. The joint part of carrying channel shall be connected by using carrying joint.
At the time of installing carrying channel make sure to install it not to be off from wall or curtain box surface more than 30 cm.

When area for works is broad reinforce and fix with supplementary channel (minor channel) installed above the carrying channel and install it with an interval of @2,000∼3,000 mm.

① Install Main AL Ω T-bar sturdily by using C/T cup toward right angle direction to carrying channel according to dimension of the product and lightline.
② Intervals for installation: for general T-bar interval is @610 mm and for Zierbart interval for installation is @600 mm.
③ It is installed by inserting CROSS Ω T-Bar Tip to hole of Main AL Ω T-bar.(Interval of hole: for general use it is @152.4 mm and for Ziebart it is @150 mm.)
④ At the time of installation of CROSS AL Ω T-Bar hole of MAIN AL Ω T-BAR shall match to hole of another MAIN AL Ω T-BAR.

① Accurately set level of installed ceiling frame by bolt and nut through using water level or level.
② Place sound absorption tex or Ziebart on Main and Cross AL Ω T-bar after its installation. (In case of sound absorption tex fix finishing plate with hold down clip.)
③ Prohibit use of finishing plate with scratch, broken corner or dirtied.

① Manufacturing and installing products suitable to use according to specification (separate painting)
② Welding work is carried out concurrently therefore install work bench to enable safety in work and working in comfortable stance.